LIMS | CAL3K Features
The LIMS (Laboratory Information Management System) is a global term describing a laboratory software that collects operational data from many laboratory instruments for the purpose …
Category: CAL3K Features
Search our library of articles:
Remote Access
All CAL3K products have a REMOTE-CONTROL feature. This allows the setting up and operation of a unit in the field via the internet. It also …
Variable Filling Pressure | CAL3K Features
The oxygen filling pressure is pre-regulated to 30 bar at the oxygen bottle. This is the standard filling pressure for bomb calorimetry. If needed and …
Three Operating Modes | CAL3K Features
APPLICABLE TO CAL3k-AP and CAL3K-A Only Isothermal, Adiabatic, and Isobatic (Dynamic) Calorimeters, in broad terms can be ISOTHERMAL or ADIABATIC. These two methods refer to …
Temperature Range | CAL3K Features
The temperature range is very linear and wide. The low end includes +1°C, and the high-end 72°C, although we only recommend a maximum operating temperature …
Printing | CAL3K Features
All units have a RS232 printer port designated as D1. The baud speed can be set from the keyboard. 8 printout formats A-H are available …
Pressure Sensor/Leak Detection | CAL3K Features
APPLICABLE TO CAL3K-AP ONLY The CAL3K-AP with automatic oxygen filling monitors the vessel pressure and reports on any leak. If a leak is detected during …
No Water Required | CAL3K Features
With the dry method, the water and container are replaced by a temperature conductive aluminium jacket which is shrunk over the stainless steel body of …
Low Power Consumption | CAL3K Features
The average power consumption is about 0.6 watt. However, just after firing the power consumption increases to 24 watts for 3 minutes in the CAL3K-A …
